Alubel SpA - coperture metalliche e rivestimenti di facciata

Metal bent sheet on design

Available developments

125 mm

150 mm

166 mm

200 mm

250 mm

312 mm

333 mm

417 mm

500 mm

625 mm

750 mm

1000 mm

1250 mm

1500 mm

	Flashings Maximum realizable length 10 m
	Copings Maximum realizable length 10 m
	Eves pipes Maximum realizable length 10 m
	Risers with serrated profile Maximum realizable length 3 m
	Ridge Maximum realizable length 10 m
	Ridge upstamds Maximum realizable length 10 m

Sigillante Alusik Il sigillante nelle sovrapposizioni di testata deve essere posato in prossimità del limite superiore della lastra sottostante e non a metà delle sovrapposizioni.
	1° Phase Prepare the surface to be sealed, in order that it is completely clean, without rust and detached particles, without grease and dry. Arranged in this way, the surface does not need any primer.
	2° Phase In correspondence of overlapping, to create a string of sealer of about 1 cm width. 3° Phase To overlap sheets, applying pressure.
	4 ° Phase Phase To apply another string of sealer all along the section fastened later with a spatula.
	5° Phase To drill the sheet and apply rivets; the distance of rivets should not be higher than 2 cm.
	6° Phase To apply another sealer on rivets and to level with spatula.